P2173 Throttle Actuator Control System - High Air Flow Detected
Description and meaning of DTC p2173
This generic powertrain diagnostic trouble code (DTC) typically applies to all OBD-II equipped vehicles that use a drive-by-wire throttle control system including but not limited to vehicles from Dodge, Jeep, Chrysler, Volvo, Fiat, Mitsubishi, etc. The P2173 OBD-II trouble code is one of number of possible codes that indicates that the Powertrain Control Module (PCM) has detected a malfunction in the operation of the Throttle Actuator Control System. The PCM sets these when other codes are present that indicate an issue that may be safety related or cause damage to the engine or drivetrain components if not corrected in a timely manner. This and related codes (P2172, P2173, P2174, and P2175) all indicate detected air flow problems. Code P2173 is set by the PCM when high air flow is detected in the throttle actuator control system. This code can be related to a Throttle Actuator Control System malfunction, but it is possible that another issue is setting this code. The Throttle Actuator Control System is duty cycle controlled by the PCM and the function of the system is limited when other fault codes are detected. Note: In the case of certain Jeep/Dodge/Chrysler vehicles, this code may be described as "High Airflow/Vacuum Leak Detected (Slow Accumulation)"
p2173 diagnostic trouble code symptoms
The severity of this code can be moderate to severe based on the specific malfunction. Symptoms of a P2173 trouble code may include: Malfunction Indicator Lamp (MIL) or ABS warning lamp illuminationEngine may not startEither no or low throttle responseAutomatic transmission will not shiftAdditional codes are possibly set
DTC p2173 - possible causes
Potential causes of the P2173 throttle engine code may include: Engine OverheatingVacuum Leaks (likely on Dodge/Chrysler/Jeep brand vehicles)Manifold Absolute Pressure MalfunctionAbnormal System Voltages
How to fix OBD-II diagnostic trouble code p2173
The first step in the troubleshooting process for any malfunction is to research the Technical Service Bulletins (TSB's) for the specific vehicle by year, model and power plant. In some circumstances this can save a lot of time in the long run by pointing you in the right direction. For example, we are aware of a bulletin that applies to certain 2007-2008 Dodge and Jeep vehicles (Compass, Patriot, Caliber), bulletin number 18-019-08 which involves this DTC and others, and the fix is to reprogram the PCM. The second step for this code is to complete a PCM scan to identify other trouble codes. This code is an informational code and in most circumstances this code's function is to alert a driver that the PCM has initiated a fail-safe mode because of a malfunction or failure in a system that is not directly related to the Throttle Control Actuator. If other codes are identified you should check for TSB's related to the specific vehicle and that code. If a TSB has not been generated you should follow the specific troubleshooting steps for that code to pinpoint the source of the malfunction that the PCM is detecting to put the engine in fail-safe or limp mode. Once all other codes have been cleared or if no other codes are detected, if the Throttle Control Actuator code still exists the PCM and Throttle Control Actuator should be evaluated. All wiring and connections should be visually inspected for obvious defects as a starting point. Common MistakeReplacing the Throttle Control Actuator or PCM when other malfunctions are setting this code. Rare RepairReplace Throttle Actuator Control Hopefully, the information in this article has been helpful to point you in the right direction to correct the problem with your Throttle Actuator Control System force code. This article is strictly informational and the specific technical data and service bulletins for your vehicle should always take priority.